Description
G19 DIY Rail Kit – Aluminum
Riptide Rails’ kits are ready to use and easy to install! The screws are already ground to the recommended 7mm length and the front pin doesn’t require a hammer to install!
Product Description
Compatible with FMDA G19 with DIY rail system
Drop-in ready
Machined from 6061 aluminum
Includes all necessary hardware and hex key (one free hex key per screw type per order)
Installation Tips
The FMDA G19 is designed to use a G26 locking block. If you have a G19 locking block, you will have to trim the front rail block or the G19 locking block to allow proper clearance between the two parts
Ream screw holes in frame to .0995″ (#40)
Ream front rail block pin hole in frame to .125″ (1/8″)
Start all screws with fingers to avoid cross-threading
What’s Included
(1) Front Rail Block
(1) Rear Left Rail
(1) Rear Right Rail
(1) 1.5mm Hex Key
(4) M2.5 x 7mm BHCS (Already ground to length)
(1) 1/8″ x 1-1/16″ Solid Pin (No hammering necessary)*
(1) 3D-Printed RailBlock
*Note: Riptide Rails’ pin diameters may differ from the developers’ original design but are still compatible with the original 3D-printed design.